General Features
77
3
•Pale
Adjust the quality level for the finish of a pale original with normal density.
The default setting is Normal.
"Custom Setting" is the value set during service setup.
• Generation Copy
Adjust the quality level so as not to thicken the lines of the finish image.
The default setting is Normal.
"Custom Setting" is the value set during service setup.
❖ Image Density
You can select one of seven original image density levels for each original
type (Text, Text/Photo, Photo, Pale, Generation Copy).
The default setting for "Text" is Normal.
The default setting for "Text/Photo" is Normal.
The default setting for "Photo" is Normal.
The default setting for "Pale" is Normal.
The default setting for "Generation Copy" is Normal.
❖ Duplex Mode Priority
You can select the type of the Duplex function effective when the power is
turned on, or modes cleared.
The default setting is 1 Sided→1 Sided (Metric version) / 1 Sided→2 Sided
(Inch version)
❖ Copy Orientation in Duplex Mode
You can set the copy orientation when making two-sided copies.
The default setting is Top to Top.
❖ Original Orientation in Duplex Mode
You can set the original orientation when making two-sided copies.
The default setting is Top to Top.
❖ Change Initial Mode
You can select standard mode or Program No.10 as the mode effective when
power is turned on, or modes cleared.
The default setting is Standard.
❖ Max. Copy Quantity
The maximum copy quantity can be set between 1 and 999.
The default setting is 99 sheet(s).
❖ Tone: Original Remains
The beeper (key tone) sounds if you forget to remove originals after copying.
The default setting is On.
If Panel Tone of User Tools (System Settings) is [Off] the beeper does not
sound irrespective of the Tone: Original Remains setting.
To Next Page
Loading...
