1. Open the bypass tray.
2. Insert the paper face down until you hear the beep, and then align the paper guides to
the paper size.
If the guides are not flush against the paper, images might be skewed or paper misfeeds might
occur.
2
1
1. Paper guides
2. Extender
3. Press [Bypass], and then press the [ ] key.
4. Select the size and type of the paper.
5. Press [OK].
6. Place the originals, and then press the [Start] key.
7. When the copy job is finished, press the [Clear Modes] key to clear the settings.
• Certain types of paper might not be detected properly when placed on the bypass tray. If this
happens, remove the paper and place it on the bypass tray again.
• Load only as much paper as can be held between the guides on the bypass tray. Overloading the
bypass tray can result in misfeeds and skewed images.
• The following paper sizes can be selected as the standard sizes:
Copying from the Bypass Tray
45
2
To Next Page
Loading...
