Facsimile Features
146
4
Reference
p.101 “Reception Settings”
p.109 “Administrator Tools”
p.131 “Parameter Settings”
p.223 “Registering Folders”
Reception File Print Qty
This section describes how to specify Reception File Print Qty.
Specify when programming a Special Sender.
A Select [Reception File Print Qty].
B Press [Number of Sets].
Selecting [Same as Basic Settings] will result in the same setting made for "RX
File Print Qty" of "Reception Settings". See "Reception Settings".
C Enter the print quantity using the number keys, and then press [OK].
Note
❒ If you make a mistake, press [Clear] or the {Clear/Stop} key before pressing
[OK], and then try again.
Reference
p.101 “Reception Settings”
To Next Page
Loading...
