Ricoh Aficio MP 7001 - Removing Staple Waste; Finisher SR4050

Removing Staple Waste
This section describes how to remove staple waste.
Finisher SR4050
The following procedure describes how to remove staple waste from the Finisher SR4050.
• While "Waste Staple Receptacle is full." is displayed, you cannot use the Staple function.
• "Waste Staple Receptacle is full." is displayed until the staple waste box is reinstalled.
• If the message is still displayed, reinstall the staple waste box.
1. Open the finisher front cover.
BQN023S
2. Pull out the staple waste box carefully, and then remove staple waste.
BQN026S
6. Clearing Misfeeds
144
6