7. Appendix
Pausing Copy When Using the Finisher SR4050
Use the following procedure to temporarily interrupt a long copy run when using the Finisher SR4050.
1. Press the [Suspend/Resume] key.
The key lights up.
2. Remove the stack of paper from the finisher shift tray.
3. Press the [Suspend/Resume] key.
The key turns off, and then copying restarts.
• You can suspend copy only when the output tray is specified as the finisher shift tray.
• Depending on the print image, the prints might not be stacked properly. In such a case, pause printing,
remove the prints, and then resume printing.
147
To Next Page
Loading...
