When an Indicator to the Right of a Function Key
Is Lit
When an indicator to the right of a function key lights up, press the corresponding function key. Then, follow
the instructions displayed on the control panel.
If an error occurs in the function you are using, check the message that appears on the control panel, and
then refer to "Messages Displayed" for the relevant function.
The following table explains problems that cause the indicator to light.
Problem Cause Solution
Documents and reports do
not print out.
The paper output tray is full. Remove the prints from the tray.
Documents and reports do
not print out.
There is no paper left. Load paper. See "Loading Paper",
About This Machine .
An error has occurred. The function whose indicator
is lit is defective.
Check the displayed message and take
an appropriate action. See "Messages
Displayed" of each chapter.
You can use other functions normally.
1. When the Machine Does Not Operate As Wanted
18
To Next Page
Loading...
