System Settings
58
2
❖ NCP Delivery Protocol
Select the protocol for NCP delivery.
•IPX Priority
• TCP / IP Priority
•IPX Only
• TCP / IP Only
If you select “IPX Only” or “TCP / IP Only”, you cannot switch the protocol
even if you cannot connect with it. If “NetWare” in [Effective Protocol] is set to
“Inactive”, you can only use TCP/IP.
❖ NW Frame Type
Select the frame type when you use NetWare.
• Auto Select
•Ethernet II
• Ethernet 802.2
• Ethernet 802.3
• Ethernet SNAP
❖ SMB Computer Name
Specify the SMB computer name.
Enter the computer name using up to 15 characters.
“*+,/:;<>=?[\]|. and spaces cannot be entered.
Do not set a computer name starting with RNP and rnp.
Use uppercase letters for alphabets.
❖ SMB Work Group
Specify the SMB work group.
Enter the computer name using up to 15 characters.
“*+,/:;<>=?[\]|. and spaces cannot be entered.
Use uppercase letters for alphabet.
❖ Ethernet Speed
Set the access speed for networks.
Select a speed that matches your network environment. [Auto Select] should
usually be selected.
• Auto Select
• 10Mbps Full Duplex
• 10Mbps Half Duplex
• 100Mbps Full Duplex
• 10Mbps Half Duplex
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
