Ricoh Aficio MP W3600 - Page 87

Remote Maintenance by telnet
79
2
❖ Configuration
• Enter “up”to enable protocol, and enter “down” to disable protocol.
You can set the protocol to "active" or "inactive".
msh> set ipv4 {up | down}
• If you disable IPv4, you cannot use remote access after logging off. If you did
this by mistake, you can use the control panel to enable remote access via IPv4.
• Disabling IPv4 also disables lpr, ftp, rsh, diprint, web, snmp, ssl, ipp, http,
bonjour, and sftp
msh> set ipv6 {up | down}
• If you disable IPv6, you cannot use remote access after logging off. If you did
this by mistake, you can use the control panel to enable remote access via IPv6.
• Disabling IPv6 also disables lpr6, ftp6, rsh6, diprint6, ssl6, ipp6, http6, and sftp6.
msh> set appletalk {up | down}
msh> set netware {up | down}
msh> set smb {up | down}
msh> set lpr {up | down}
msh> set lpr6 {up | down}
msh> set ftp {up | down}
msh> set ftp6 {up | down}
msh> set rsh {up | down}
msh> set rsh6 {up | down}
msh> set diprint {up | down}
msh> set diprint6 {up | down}
msh> set web {up | down}
msh> set snmp {up | down}
msh> set ssl {up | down}
msh> set ssl6 {up | down}
• If Secured Sockets Layer (SSL, an encryption protocol) function is not
available for the printer, you cannot use the function by enabling it.
msh> set nrs {up | down}
msh> set rfu {up | down}
msh> set rfu6 {up | down}
msh> set ipp {up | down}
msh> set ipp6 {up | down}
msh> set http {up | down}
msh> set http6 {up | down}
msh> set bonjour {up | down}
msh> set ssh {up | down}
msh> set ssdp {up | down}
msh> set nbt {up | down}
msh> set sftp {up | down}
msh> set sftp6 {up | down}