Getting Started
38
1
Saving Energy
This machine has the following energy saving functions.
❖ Energy Saver
If you do not use the machine for a certain period after an operation, or when
you press the {Energy Saver} key, the display disappears and the machine
goes into Energy Saver mode. When you press the {Energy Saver} key again,
the machine returns to the ready condition. The machine uses less electricity
in Energy Saver mode.
You can change the amount of time the machine waits before switching to En-
ergy Saver mode after copying has finished or the last operation is performed.
See “Timer Settings”, General Settings Guide.
❖ Low power mode
If you do not use the machine for a certain period, it automatically lowers its
power consumption. When you press the {Energy Saver} key, the machine re-
turns to standby.
You can change the amount of time the machine waits before switching to the
Low power mode. See “Timer Settings”, General Settings Guide.
❖ Auto Off
The machine automatically turns itself off when the job is finished, after a cer-
tain period of time has elapsed. This function is called “Auto Off”.
You can change the Auto Off time. See “Timer Settings”, General Settings
Guide.
Note
❒ The Energy Saver, Low power mode, and Auto Off function will not operate
in the following cases:
• When a warning message appears
• When the service call message appears
• When paper is jammed
• When the cover is open
• When the “
Add Toner” message appears
• When toner is being replenished
• When the User Tools / Counter / Inquiry screen is displayed
• When fixed warm-up is in progress
• When the printer, or other functions are active
• When operations are suspended during printing
• When the Data In indicator is on or blinking
• When the screen of stored document under the printer function is displayed
Reference
“Timer Settings”, General Settings Guide
To Next Page
Loading...
