• Names beginning with "RNP" or "rnp" cannot be entered.
Working group name settings
msh> smb group "work group name"
• Set workgroup name using up to 15 characters.
Comment settings
msh> smb comment "comment"
• Set comment using up to 31 characters.
Notify print job completion
msh> smb notif {on|off}
• To notify print job completion, specify "on". Otherwise, specify "off".
Deleting computer name
msh> smb clear comp
Deleting group name
msh> smb clear group
Deleting comment
msh> smb clear comment
View protocol
msh> smb protocol
snmp
Use the "snmp" command to display and edit the SNMP configuration settings such as the community name.
View settings
"IPX" is shown only when the NetWare is installed.
msh> snmp
• Default access settings 1 is as follows:
Community name:public
IPv4 address:0.0.0.0
IPv6 address:::
IPX address:00000000:000000000000
Access type:read-only
Effective Protocol:IPv4/IPv6/IPX
• Default access settings 2 is as follows:
Community name:admin
Remote Maintenance Using telnet
155
To Next Page
Loading...
