Error Codes
D361 30 SM
Code Meaning Suggested Cause/Action
memory overflowed during the transaction.
15-93 Memory Access Error
Transaction could not complete due to a
malfunction of SAF memory.
15-94 Incorrect ID Code
The machine rejected an incoming e-mail for
transfer request, because the ID code in the
incoming e-mail did not match the ID code
registered in the machine.
15-95 Transfer Station Function
The machine rejected an incoming e-mail for
transfer because the transfer function was
unavailable.
22-00
Original length exceeded
the maximum scan
length
Divide the original into more than one page.
Check the resolution used for scanning. Lower
the scan resolution if possible.
Add optional page memory.
22-01
Memory overflow while
receiving
Wait for the files in the queue to be sent.
Delete unnecessary files from memory.
Transfer the substitute reception files to
another fax machine, if the machine’s printer is
busy or out of order.
Add an optional SAF memory card or hard
disk.
22-02
Tx or rx job stalled due to
line disconnection at the
other end
The job started normally but did not finish
normally; data may or may not have been
received fully.
Restart the machine.
22-04
The machine cannot
store received data in the
SAF
Update the ROM
Replace the FCU.
22-05
No G3 parameter
confirmation answer
Defective FCU board or firmware.
To Next Page
Loading...
