Error and Status Indicate on the Control Panel
Codes on the Screen
Code Causes Solutions
E0 Paper has been jammed in the machine.
• Remove the jammed paper. See p.52
"Paper Feed Problems".
E1
Paper has been jammed in the paper
tray.
The input tray has run out of paper.
• Remove the jammed paper. See p.52
"Paper Feed Problems".
• Load paper to the input tray. See p.19
"Loading Paper".
E2
The paper for making copies, printing
faxes or Auto Report is not loaded.
Load the appropriate size paper.
E3 A maintenance cover is open. Close the maintenance cover completely.
E4 Front cover is closed. Open the front cover completely.
E5
An appropriate size paper for printing
Report is not loaded.
Load A4 or Letter size paper in the input tray.
E6
The print cartridge has not been
installed.
Reinstall the print cartridge. See p.45
"Replacing the Print Cartridge".
E7 The machine has run out of the toner.
Replace the print cartridge. See p.45
"Replacing the Print Cartridge".
E8 The print cartridge is almost empty. Prepare a new print cartridge.
E9
An appropriate size paper for making
copies is not loaded.
Load the appropriate size paper.
P1
The paper size set for the document
differs from the size of the paper.
Press the [Start] key to begin printing, or press
the [Clear/Stop] key to cancel the job.
P2
The paper type set for the document
differs from the type of the paper.
Press the [Start] key to begin printing, or press
the [Clear/Stop] key to cancel the job.
Error and Status Indicate on the Control Panel
61
To Next Page
Loading...
