• For details about printing the Speed Dial list, see p.291 "Printing Lists/Reports".
Specifying the destination from an LDAP server
This section describes how to select a destination registered on the LDAP server.
• To search for a destination from an LDAP server, the LDAP server must be registered in advance,
and [LDAP Search] must be enabled under the LDAP server settings.
1. Press the [Facsimile] key.
2. Press the [Address Book] key.
3. Press the [ ][ ] keys to select [Search LDAP], and then press the [OK] key.
4. Press the [ ][ ] keys to select [Start LDAP Search], and then press the [OK] key.
A list of destinations that match the search conditions appears on the display (up to 50).
5. Press the [ ][ ] keys to scroll through the search result, and then press [ ] to select the
desired destination.
You can select multiple destinations. A check mark will appear for the selected destinations. To
deselect a destination, press [ ] again.
Sending a Fax
217
To Next Page
Loading...
