6. Fasten the Gigabit Ethernet board to the controller board with two screws.
Check the Gigabit Ethernet board is connected firmly to the controller board.
• Use a coin or similar object if the screws do not turn easily.
• After finishing installation, check the Gigabit ethernet board is installed properly: print the
configuration page from the [List/Test Print] menu. If it is installed properly, you will see "Gigabit
Ethernet" for "Device Connection" on the configuration page.
• If the Gigabit ethernet board is not installed properly, reinstall it following this procedure. If you cannot
install it properly even after attempting reinstallation, contact your sales or service representative.
• You need to make settings with the control panel before using the Gigabit Ethernet board. For details,
see "Ethernet Configuration".
• "Printing the Test Page", Quick Installation Guide.
• p.53 "Ethernet Configuration"
Attaching Gigabit Ethernet Board Type A
39
To Next Page
Loading...
