Attaching 1394 Interface Unit Type 4510
41
3
H Remove the two screws and the
cover of the 1394 interface unit
mounting bracket.
Note
❒ These screws are used again in
fastening the 1394 interface unit
to the controller board.
❒ The removed cover is not used
when installing the 1394 inter-
face unit.
I Attach the 1394 interface unit to
the controller board.
Insert the end of the 1394 interface
unit into the opening ( ), and then
push down until it clicks ( ).
J Fasten the 1394 interface unit to
the controller board.
K Match the controller board to the
top and bottom rail using the “T”
mark, and then slide it into the
printer slowly until it stops.
L Push back the handle of the con-
troller board until it clicks.
ZKGX410E
ZKGX421E
ZKGX430E
ZKGX443E
ZKGX252E
ZKGX380E
KirP4GB_Setup-F6_FM_forPaper.book Page 41 Thursday, May 12, 2005 11:28 AM
To Next Page
Loading...
