Loading Paper
17
1
E Press the {U} or {T} key to dis-
play the loaded paper size, and
then press the {# Enter} key.
After about two seconds, the dis-
play returns to the menu.
F Press the {Online} key.
The initial screen appears.
This completes the setting change.
Specifying custom size paper for the
optional paper feed unit
Important
❒ When printing on custom size pa-
per, specify the paper size using
the control panel or printer driver.
❒ The custom size paper selected us-
ing the printer driver overrides
that selected using the control pan-
el. Do not make settings using the
control panel if you have already
made settings using the printer
driver. However, when printing
with a printer driver other than the
RPCS printer driver, you must
configure the settings using con-
trol panel.
❒ The following is the range of paper
sizes that can be loaded in each
type of the paper trays:
• Optional paper feed unit (Tray
2, Tray 3): 182 - 297 mm in width
and 60 - 432 mm
❒ The printer cannot print from ap-
plications that do not support cus-
tom size paper.
A Press the {Menu} key.
The [Menu] screen appears on the
display.
B Press the {U} or {T} key to dis-
play [Paper Input], and then press
the {# Enter} key.
The paper selection menu appears.
C Press the {U} or {T} key to dis-
play [Tray Paper Size], and then
press the {# Enter} key.
The paper tray selection menu ap-
pears.
D Press the {U} or {T} key to dis-
play the target paper tray, and
then press the {# Enter} key.
The paper size selection menu ap-
pears.
E Press the {U} or {T} key to dis-
play [Custom Size], and then press
the {# Enter} key.
Tray 2:
8 1/2 x 13
Menu:
Paper Input
Tray Paper Size:
Tray 2
AGN503S
KirP4GB_Mainte-F6_FM_forPaper.book Page 17 Thursday, May 12, 2005 11:48 AM
To Next Page
Loading...
