SERVICE PROGRAM MODE
SM 4-53 B089/B093
Service
Tables
5857 Debug Log Save Function
On/Off (1:ON 0:OFF) 0: OFF, 1: ON 5857 1
Switches the debug log feature on and off. The debug log cannot be captured until
this feature is switched on.
Target (1:IC Card 2:HDD) 1:IC Card, 2:HDD 5857 2
Select “1” (IC Card) if an HDD unit is not installed in the machine, or if the HDD
unit is temporarily out of service. The IC card can store only 4 MB so use the HDD
selection.
Initialize IC Card
DFU
5857 3
Initializes the IC card inserted into the controller slot. Initializing erases all data on
the IC card. Use to initialize a new card.
Save to IC Card
DFU
5857 4
Saves the debug log in memory to the IC card.
Save to HDD
DFU
5857 5
Saves the debug log in memory to the HDD.
A unique file name is generated to avoid overwriting existing file names on the IC
card. Up to 4MB can be copied to an IC card. 4 MB segments can be copied one
by one to each IC card.
HDD to IC Card (Latest 4MB) 5857 7
Copies the latest 4 MB of the debug log on the HDD to the IC card. This function
erases all data from the IC card as it copies.
HDD to IC Card (Latest 4MB Any Key) 5857 8
Copies the latest 4 MB of the debug log on the HDD to the IC card, but only those
portions of the log specified with a key specified with SP5859 (Debug Save Key
No.) This function erases all data from the IC card as it copies.
To enable this SP, the machine must be cycled off and on.
Erase Debug Data From HDD DFU. 5857 11
Erases all debug log data from the IC card.
Debug Log Save Function 5858
These SPs select the content of the debugging information to be saved to the
destination selected by SP5857 2.
SP5858 3 stores one SC specified by number. Refer to Section 4 for a list of SC
error codes.
5858 1 Engine SC Error Stores SC codes generated by copier engine errors.
5858 2 Controller SC Error Stores SC codes generated by RA2K controller errors.
5858 3 Any SC Error [0~65535 / 0 / 1]
5858 4 Jam Stores jam errors.
5859 Debug Log Save Function
5859 1 Key 1
5859 2 Key 2
5859 3 Key 3
5859 4 Key 4
5859 5 Key 5
5859 6 Key 6
5859 7 Key 7
5859 8 Key 8
5859 9 Key 9
5859 10 Key 10
These SPs allow you to set up to 10 keys for log files for
functions that use common memory on the controller
board. (!5.3.1)
[-9999999~9999999 / 0 / 1]
To Next Page
Loading...
