SERVICE PROGRAM MODE
B089/B093 4-54 SM
5860
SMTP/POP3/IMAP4
5860 20 Partial Mail Receive Timeout
[1~168 / 72 / 1]
Sets the amount of time to wait before saving a mail that breaks up during
reception. The received mail is discarded if the remaining portion of the mail is
not received during this prescribed time.
5860 21 MDN Response RFC2298 Compliance
[0~1 / 0 /1]
Determines whether RFC2298 compliance is switched on for MDN reply mail.
0: No compliance.
1: Compliance. The MAIL FROM (SMTP command) is sent open (< >).
5860 22 SMTP Auth. From Field Replacement
[0~1 / 1 / 1]
Determines whether the FROM item of the mail header is switched to the
validated account after the SMTP server is authorized.
5870 Common Key Info Writing
Writes to flash ROM the common proof for validating the device for NRS
specifications.
5871 HDD Function Disable DFU [0~1 / 0 / 1] (0: OFF, 1: ON)
Disables the HDD functions by suppressing all functions that write data to the
HDD. After this SP is executed, the machine must be switched off and on to
enable the setting.
Note: This SP is intended for use during the installation of the security DIMM,
an option that is not yet available.
5872 HDD Overwrite Status Check
DFU
Plug & Play Setting 5907*
Sets the brand name and the production name for Windows Plug & Play. This
information is stored in NVRAM. If the NVRAM is defective or has been replaced,
these names should be registered again.
Allows input of the maker and model on a two-line display. After replacing the
NVRAM, the settings can be selected from available maker and model names.
To select and enable the maker & model name:
1 Press and hold down .
2 Enter the number that corresponds to the correct name on the list.
LCT Paper Size 5908*
Selects the paper size for the LCT. Use this SP after changing the paper size in
the optional LCT (i.e., after changing the side plate position for the LCT).
[0~1 / 1 / 1] North America
0: A4
1: LT
[0~1 / 0 / 1] Other Areas (Europe/Asia)
0: A4
1: LT
⇒
⇒
⇒
Rev. 06/2004
To Next Page
Loading...
