COVER INTERPOSER TRAY (B704)
B132/B200 1-110 SM
Attaching the Corner Plates for the B706
Important:
• The corner plates are installed on the B706 only.
Right Rear Corner Plate (B706 only)
1. Temporarily attach the screws [A] (with approximately two turns) to the right
end of the finisher extension table [B] ( x 2, tapping M4 x 8)
NOTE: You cannot see the holes, because they have tape on them. You can
punch the screws through the tape.
2. Align the notches [C] in the right rear corner plate [D] with the screws and
attach the plate.
3. Put a long screwdriver through the notches in the right rear corner plate [D].
Then, tighten the screws to attach the right rear corner plate to the table
extension [B].
NG
OK
B704I112.WMF
[A]
[B]
[C]
[D]
To Next Page
Loading...
