COVER INTERPOSER TRAY (B704)
SM 1-111 B132/B200
Installation
4. Temporarily attach the screw [A] (M4 x 8) with approximately two turns, to
fasten to the panel at the right front corner.
NOTE: You cannot see the hole, because it has tape on it. You can punch the
screw through the tape.
5. With the clamp [B] below the edge of the corner, align the notch [C] in the right
front corner plate with the screw, then put the panel into its position. You will
hear a click when it is in the correct position.
6. Put a long screwdriver in the notch [C], and tighten the screw to attach the right
front corner plate.
B704I111.WMF
[A]
[B]
[C]
To Next Page
Loading...
