MFP CONTROLLER OPTIONS
B132/B200 1-140 SM
Seal Check And Removal
CAUTION
Before you start the installation, you must check the box seals to make
sure that they were not removed after the items were sealed in the box at
the factory.
1. Check the box seals [A] on each corner of the box.
• Make sure that a tape is attached to each corner.
• The surfaces of the tapes must be blank. If you see “VOID” on the tapes, do
not install the components in the box.
2. If the surfaces of the tapes do not show “VOID”, remove them from the corners
of the box.
3. When you remove each seal, the “VOID” marks [B] can be seen. In this
condition, they cannot be attached to the box again.
4. Copy the DOS card to another application’s SD card (for example, the
printer/scanner or PostScript card).
5. After you copy the DOS card, store it behind the door. Use the combined
DOS/other application SD card for the next part of the installation procedure.
B692I901.WMF
B692I903.WMF
[B]
[A]
To Next Page
Loading...
