MFP CONTROLLER OPTIONS
SM 1-141 B132/B200
Installation
Installation Procedure
CAUTION
The machine should always be turned off and its power cord disconnected
before you do this procedure.
1. If the machine is on, turn off the main power switch.
2. Disconnect the network cable (if the
machine is connected to a network).
3. Remove the slot cover [A] ( x 2).
4. Install the SD Card [B] into slot 2,
then attach the slot cover.
5. Connect the network cable (if the
machine is connected to a network).
6. Turn the main power switch on.
B132I909.WMF
[A]
[B]
To Next Page
Loading...
