DUPLEX UNIT
B132/B200 3-106 SM
[A]: Jogger fences ( x 1 ea.)
[B]: Left transport cover ( x 2)
• The front screw is a shoulder screw. Insert the screws in the correct holes
when re-attaching.
• To avoid breaking the tabs under the left edge of the table, pull the table to
the right to disengage the tabs and then remove.
[C]: Transport sensor 1 (x 1, x 1)
[D]: Transport sensor 2 (x 1, x 1)
[E]: Inverter exit sensor ( x 1, x 1, x 1)
Reinstallation
• Make sure the end tabs [F] of the left transport cover are engaged correctly.
B132R507.WMF
[A]
[B]
[C]
[D]
[E]
[F]
[F]
To Next Page
Loading...
