SERVICE CALL CONDITIONS
B132/B200 4-30 SM
Laser Synchronization Detector Error 1: K Leading Edge: LD0
SC220 D
While the polygon motor is
rotating normally, no
synchronizing detection signal is
output for LD0 black, or leading
edge, even after the laser diode
has been firing for 2 sec.
• Harness between the laser synchronizing
detector and I/F unit is disconnected,
defective
• Laser synchronizing detector defective
• Beam not reflected in photo detection
• GAVD on the BICU is defective
• LD driver board defective
• LDB defective
• BCU defective
• Check board connections, replace
Laser Synchronization Detector Error 2: K Leading Edge (Other than LD0)
SC221 D
While the polygon motor is
rotating normally, no
synchronizing detection signal is
output for black, leading edge for
any LD other than LD0, even
after the laser diode has been
firing for 2 sec.
• Beam not reflected in photo detection
• GAVD on the BICU defective
• LD driver defective
• LDB defective
• BCU defective
• Check board connections, replace
Laser Synchronization Detector Error 1: Y Leading Edge: LD0
SC222 D
While the polygon motor is
rotating normally, no
synchronizing detection signal is
output for LD0 yellow, leading
edge, even after the laser diode
has been firing for 2 sec.
• Harness between the laser synchronizing
detector and I/F unit is disconnected,
defective
• Laser synchronizing detector defective
• GAVD on the BICU defective
• LD driver board defective
• LDB defective
• BCU defective
• Check board connections, replace
Laser Synchronization Detector Error 2: Y Leading Edge (Other than LD0)
SC223 D
While the polygon motor is
rotating normally, no
synchronizing detection signal is
output for yellow, leading edge
for any LD other than LD0, even
after the laser diode has been
firing for 2 sec.
• Beam not reflected in photo detection
• GAVD on the BICU defective
• LD driver defective
• LDB defective
• BCU defective
• Check board connections, replace
To Next Page
Loading...
