Ricoh B132 - Copier Service Tables; Group 1000

SERVICE PROGRAM TABLES
B132/B200 5-22 SM
5.5.2 COPIER SERVICE TABLES
Group 1000
1001 Lead Edge Reg Leading Edge Regisration Adjustment
001 Adjusts the printing leading edge registration using the trimming area pattern
(SP2109, Pattern No. 10).
[–9~+9/0.1mm]
Specification: 3±2mm
1002 Side-to-Side Reg Side-to-Side Registration Adjustment
Adjusts printing side-to-side registration for each feed station, using the test
pattern (SP2109, Pattern No. 10).
These SP’s should be adjusted after replacing the laser synchronization detector or
the laser optical unit.
001 Tray 1 [–9~+9/0.1 mm]
002 Tray 2
003 Tray 3
004 Tray 4 Japan Only
005 Bypass Tray
006 LCT
007 Dupx Tray
1003 Reg Buckle Adj Registration Buckle Adjustment
Adjusts the registration motor timing. This timing determines the amount of paper
buckle at registration. (A higher setting causes more buckling.)
001 Trays & LCT [–9~+9/1 mm]
002 Dupx Tray [–9~+9/1 mm]
003 Bypass Tray [–9~+9/1 mm]
1007 Bypass Size Disp Bypass Paper Size Detection Display
Use this SP to display and confirm the size of the paper detected in the by-pass tray
if paper is skewing during feeding.
[0~255/1 mm]
1008 Duplex Fence Adj Duplex Side Fence Position Adjustment
Allows fine adjustment of the distance between the edges of the sheet and the
jogger fences when the fences come together to position the sheet in the duplex
unit.
[-3~+3/0.1 mm]