Ricoh B132 - Page 540

SERVICE PROGRAM TABLES
B132/B200 5-62 SM
2623 TEdge Cor:OHP K – PTR Trailing Edge Correction for Transparency: K
Sets the strength of the bias coefficient for the bias applied at the trailing edge when
the image is transferred from ITB to paper. Applied when printing in black-and-white
mode on OHP at half-speed (128~256 g/m
2
).
2624 TEdge SWT:OHP K – PTR Trailing Edge Switch Timing for Transparency: K
Sets the switch timing that determines the distance from the leading edge where the
SP2623 002 setting is applied during image transfer from ITB to paper. Applied only
when printing in black-and-white mode on OHP at half speed (128~256 g/m
2
).
2623 2624
[0~400/1%] [-100~0/1%]
2626 LEdge Cor:OHP FC Leading Edge Correction for Transparency: FC
These SPs do the following settings when printing on OHP in the full-color mode at
half-speed (128~256 g/m
2
):
1) ITB: Sets the correction coefficient for the application of bias when the image is
transferred from the drum to the ITB. The selected value is the distance in mm from
the leading edge.
2) PTR: Sets the correction coefficient for the application of bias when the image is
transferred from ITB.
3) SepDC, SepAC: Set the dc/ac charges applied to neutralize the charges on the
belt and paper so they will separate more easily.
Note: SP2626 selects the strength of the bias coefficient, and SP2627 sets the start
timing of the bias application.
2627 LEdge SWT:OHP FC Leading Edge Switch Timing for Transparency: FC
Sets the switch off timing of SP2626. The selected value is the number of mm from
the leading edge. Applies only to printing in full-color mode on OHP in half-speed
mode (128~256 g/m
2
).
2626 2627
001 ITB [0~400/1%] [0~30/1 mm]
002 PTR [0~400/1%] [0~30/1 mm]
003 SepDC [0~400/1%] [0~30/1 mm]
004 SepAC [0~400/1%] [0~30/1 mm]
2628 TEdge Cor:OHP FC – PTR Trailing Edge Correction for Transparency: FC
Sets the start timing for SP2629 002 at the trailing edge. Applied to the trailing edge
for full-color printing on OHP at half-speed (128~256 g/m
2
).
2629 TEdge SWT:Thk FC – PTR Switch Timing for Transparency: FC
Sets the switch timing that determines the distance from the leading edge where the
settings of SP2628 002 are applied during image transfer from ITB to OHP during
full-color printing at half-speed (128~256 g/m
2
).
2628 2629
[0~400/1%] [-100~0/1%]