SERVICE PROGRAM TABLES
SM 5-71 B132/B200
Service Tables
2826 LEdge Cor:Sp2 FC Leading Edge Correction for Special Paper 2: FC
These SPs do the following settings when printing on Special Paper 2 in the full-
color mode:
1) ITB: Sets strength/timing of the correction coefficient for the application of bias
when the image is transferred from the drum to the ITB.
2) PTR: Sets the strength/timing of thecorrection coefficient for the application of
bias when the image is transferred from ITB.
3) SepDC, SepAC: Set the strength/timing of the dc and ac charges applied to
neutralize the charges on the belt and paper so they will separate more easily.
Note: SP2826 selects the strength of the bias coefficient, and SP2827 sets the start
timing of the bias application.
001 ITB [0~400/5%]
007 Side1:PTR
008 Side1:SepDC
009 Side1:SepAC
012 Side2:PTR
013 Side2:SepDC
014 Side2:SepAC
2827 LEdge SWT:Sp2 FC Leading Edge Switch Timing for Special Paper 2: FC
Sets the switch off timing of SP2826. The selected value is the number of mm from
the leading edge. Applies only to printing in full-color mode on Special Paper 2.
001 ITB [0~30/1 mm]
002 PTR
003 SepDC
004 SepAC
2828 TEdge Cor:Sp2 FC – PTR Trailing Edge Correction for Special Paper 2: FC
Sets the strength of the bias coefficient for the bias applied at the trailing edge when
the image is transferred from ITB to paper. Applied when printing in full-color mode
on Special Paper 2.
007 Side1:PTR [0~400/5%]
012 Side2:PTR
2829 TEdge SWT:Sp2 FC – PTR Switch Timing for Special Paper 2: FC
Sets the switch timing that determines the distance from the leading edge where the
SP2828 settings are applied during image transfer from ITB to paper. Applied only
when printing in full-color mode on Special Paper 2.
[-100~0/1 mm]
To Next Page
Loading...
