SERVICE PROGRAM TABLES
B132/B200 5-84 SM
3194 ID Coeff Display ID Sensor Sensitivity Coefficient Display
Displays the most recent and averaged readings of the sensitivity correction coeffients
(K2 and K5).
001 K2:Col:Last
002 K5:Col:Last
005 K2:Col:Ave
006 K5:Col:Ave
[0~10000/0]
3251 Tnr Supply Time Toner Calibration Time: Display
Displays for confirmation the length of time the sub hopper clutch remained on to send
toner to the sub hopper after a new toner cartridge was installed.
001 K
002 M
003 C
004 Y
[0~10000/1 sec.]
005 Toner Pump CL:K
006 Toner Pump CL:M
007 Toner Pump CL:C
008 Toner Pump CL:Y
Use these SPs to display the accumulated drive time for
each powder pump clutch before installing a new one.
These SPs are reset to zero after the clutches are replaced.
3301 Tnr Supply Select Toner Supply Method
001 K
002 M
003 C
004 Y
[0~2/1]
0: Fixed toner supply
1: PID Toner Supply
Only use this for specified troubleshooting procedures in Section "4
Troubleshooting".
3302 Tnr Supply Select Toner Supply Rate
Sets the toner supply rate for fixed toner supply mode. The rate is set by adjusting the
on time of the toner supply clutch. This setting is used only if SP3301 is set to "0".
001 Supply Rate:K
002 Supply Rate:M
003 Supply Rate:C
004 Supply Rate:Y
[0~100/1%]
To Next Page
Loading...
