Ricoh B234 - Page 105

SERVICE CALL CONDITIONS
SM 4-103 B234/B235/B236/D101/D102/D103
Trouble-
shooting
2. Do SP5801-019 then switch the machine OFF.
3. Install the HDD again and switch the machine ON.
4. Do SP5832-004.
5. Cycle the machine OFF/ON.
6. Do SP9730-002 and set to "1" (ON).
7. Do SP9730-003 and set to "1" (ON).
8. Do SP9730-004 and set to "1" (ON).
9. Cycle the machine OFF/ON.
Media Link Board Error
SC880 D
A request for access to the Media Link Board
was not answered within the specified time.
• Media Link Board defective
Electrical Total Counter Error
SC900 C
The total counter contains data
that is not a number.
• NVRAM disturbed unexpectedly
• NVRAM defective
• NVRAM data corrupted
Mechanical Total Counter Error
SC901 B
The mechanical total
counter is disconnected.
• User removed the counter while it was operating
• Poor connection
• Mechanical total counter defective
SC910 D
External Controller Error 1
SC911 D
External Controller Error 2
SC912 D
External Controller Error 3
SC913 D
External Controller Error 4
SC914 D
External Controller Error 5
The external controller alerted
the machine about an error.
• Please refer to the instructions for the
external controller.
External Controller Error 6
SC919 B
While EAC (External Application Converter),
the conversion module, was operating
normally, the receipt of a power line interrupt
signal from the FLUTE serial driver was
detected, or BREAK signal from the other
station was detected.
• Power outage at the EFI
controller
• EFI controller was
rebooted
• Connection to EFI
controller loose
Printer Error 1
SC920 D
An internal application error was
detected and operation cannot
continue.
• Software defective; switch off/on, or
change the controller firmware if the
problem is not solved
• Insufficient memory
Printer Error 2
SC921 D
When the printer application
started, the font to use could not
be found on the SD card.
• The font is not on the SD card