REPLACEMENT AND ADJUSTMENT
SM 9 B833
Multi Bypass
Tray
B833
1.8 PICK-UP SOLENOID
1. Remove the rear, front, and top covers. (1.2)
2. Remove the pick-up solenoid [A] ( x 2, x 1, harness clamp x 1)
NOTE: When re-installing the solenoid, make sure that the arm of the solenoid is
positioned above and in contact with the plate of the pick-up roller shaft
below. To confirm correct installation, manually move the solenoid to the
left and right. When the solenoid plunger is moved, the pick-up roller
should move up and down smoothly.
B833R921.WMF
[A]
To Next Page
Loading...
