Ricoh B234 - Paper Size Detection Table; Selecting the Paper Size for Undetectable Sizes

DETAILS
SM 15 B833
Multi Bypass
Tray
B833
Paper Size Detection Table
Paper Width SW Area
Paper Size
1 2 3 4 5
Length
Sensor
NA EU
12" x 18"
O O
13" x 19"
P P
Large
320 x 340 mm
H H H H L L
P P
A3 SEF 297 x 420 mm L
O
O
A4 LEF 297 x 210 mm
H H H L L
H
O
O
DLT SEF 11" x 17" L
O
O
LT LEF 11" x 81/2"
H H H L H
H
O
O
B4 SEF 257 x 364 mm L
O
O
B5 LEF 257 x 182 mm
H H L L H
H
O
O
A4 SEF 210 x 297 mm
P
O
LT SEF 81/2" x 11"
L
O
P
A5 LEF 210 x 148 mm
P
O
HLT LEF 81/2" x 51/2"
H H L H H
H
O
P
B5 SEF 182 x 257 mm
P
P
F SEF 8" x 13"
H L L H H L
O
O
A5 SEF 148 x 210 mm H L H H H H
O
O
HLT SEF 51/2 " x 81/2 " L L H H H H
O
O
B6 SEF 128 x 182 mm
P P
A6 SEF 105 x 148 mm
O O
Post-
card
100 x 148 mm
L H H H H H
P P
Table Key
1, 2, 3, 4,
and 5
The paper size switch consists of 5 feelers that slide along the wiring patterns
of the paper width switch terminal plate when the side fences are manually
adjusted to fit the size of the paper loaded in the tray. The H, L status of each
feeler is determined by whether the feeler is in contact with the wire of a
pattern.
H High (5 V) (Inactive)
L Low (0 V) (Active)
O
The machine determines the paper size automatically by reading the output of
the paper size switches and the paper length sensor.
P
The machine cannot detect the paper size automatically. The user must select
the paper size manually before starting the job. See below.
Selecting the Paper Size for Undetectable Sizes
Press the [Tray Paper Settings] key on the operation panel to select paper sizes
that are not detected automatically by the combination of paper size and paper
length sensor readings (marked “P” in the table above and any other paper size
not listed that requires pulling out the paper tray extension).
NOTE: Mixed paper sizes cannot be loaded into the bypass tray. Loading paper of
different sizes will cause a paper jam.