REPLACEMENT AND ADJUSTMENT
SM 17 B834
LCIT
B834
1.10 SIDE REGISTRATION ADJUSTMENT
Normally the side registration of the image can be adjusted with SP1002 004~006
(Side-to-Side Registration – Tray 4, 5, 6). When the punch hole positions are not
aligned from a particular feed station, adjust the side registration by changing the
tray cover position for the tray, as described below. Then adjust the side
registration of the image with the SP1002.
1. Pull out the tray.
2. Change the screw positions [A] at both the right and left sides as shown.
NOTE: Adjustment range: 0 ± 2.0 mm adjustment step: 1.0 mm/step
B834R112.WMF
[A]
To Next Page
Loading...
