Z-FOLDING UNIT ZF4000 (B660)
B234/B235/B236/D101/D102/D103 1-84 SM
Preparing for Docking
1. Remove the tape from the sponge [A] and attach it to the Z-folding unit.
2. Remove the top cover [B] ( x 4).
3. Remove the seal from the double-sided tape on the bottom of the front spacer
[C], then attach the front spacer [C].
4. Remove the seal from the double-sided tape on the bottom of the rear spacer
[D], then attach the rear spacer [D].
NOTE: The spacers align the top of the Z-folding unit with the edge of the
Copier.
5. Reattach the top cover [B] ( x 4).
NOTE: Make sure that the top cover is level with the tops of the rear and front
spacers.
B660I005.WMF
B660I010.WMF
[A]
[B]
[C]
[D]
5 mm
65 mm
To Next Page
Loading...
