DETAILS
B836 30 SM
2.5 BOOKLET OUTPUT TRAY
The booklet output tray sensor actuator arm [A] rests on the top of the stack of
stapled booklets as they are output to the booklet output tray. A flap depressor [B]
keeps the open ends of the booklets down.
The front booklet output tray full sensor [C] and rear booklet output tray full sensor
[D] detect when the booklet output tray is full of booklets.
Important
• The front booklet output tray full sensor is mounted higher than the rear booklet
output tray full sensor.
• The booklet output tray is stationary. When it becomes full, the stapling and
folding job stops until booklets are removed from the tray.
• If the booklet output tray is not installed (this is detected if the front and rear
sensors remain OFF), the machine will not operate in the booklet staple and fold
mode. When booklet mode is selected, the tray full message appears on the
operation panel.
The combinations of the two actuators and two sensors as the actuator arm rises
determines the number of booklets that the booklet output tray can hold before the
job stops.
B836D908.WMF
Full 1
Full 2
Full 3
Ready
[A]
[B]
[C]
[D]
To Next Page
Loading...
