23
TURN COUNTER-
CLOCKWISE
• If the punched-holes are too close to the front of the machine, then you must turn the adjustment
screw clockwise.
TURN
CLOCKWISE
• Using a flat-head screwdriver, turn the adjustment screw clockwise or counter-clockwise to move
the die set position cradle.
NOTE: Seven full turns of the adjustment screw result in a ¼” change in the punched hole
position.
• Before tightening the lock-down screw, tilt or bias the assembly towards the bottom of the machine
and tighten the lock-down screw. This will ensure positive engagement between the locking lever
and the die set.
TILT TO BOTTOM
OF M/C
SCREW
TIGHTEN
• Run a test sample of punched paper and recheck paper alignment. Re-adjust if necessary.
To Next Page
Loading...
