Ricoh B234 - Green Belt Replacement, Paper Exit Side

30
Step 25: Attach the Docking Plate using “4” Screws.
Step 26: Attach the Back Rear Cover using the 7 screws (2 for the Entrance and 5 for the Exit
side).
Test the StreamPunch by running 10 copies in bypass mode,
Then 1 sheet in punch mode,
Then 10 sheets in punch mode,
Then 100 sheets in punch model
This entire process takes approximately 60 minutes. First time maybe a little longer.
AFTER ASSEMBLY
4.6 GREEN BELT REPLACEMENT, PAPER EXIT SIDE
The following step-by-step directions inform you how to remove and then assembly the components
necessary to access the Paper Exit Side Aligner Green Belt, P/N VRC51019.
It will help you to reference your StreamPunch Service Manual part drawings as you follow this
process.
Special Tools Required:
• Twelve inch metal ruler or similar straight edge.
• Phillips Head Screw Driver 7” or less in total length.
• Alan wrenches.
• Nut Driver
• Rare Earth Magnet Snake Neck (optional – good for retrieving any hardware that happens to fall in
hard to reach spots)
• Snap Ring pliers
• E-Ring tool
NOTE: During assembly, be sure not to over tighten any of the mounting screws.
Step 1: Disconnect the StreamPunch from Power. Retain the power cord in your possession for
your safety.
Step 2: Disconnect the Communication Cable to the Finisher.
Step 3: Unlatch the GBC StreamPunch from both the Finisher and the Printer.
NOTE: You must first remove the screw that secures the latch in place (if so
equipped).
Step 4: Open the front door (A) of the StreamPunch.