31
BINDER SIDE
Step 5: To remove the Rear Cabinet/Cover (B) of the StreamPunch,
A. Remove the 5 screws on Exit side and 2 screws on Entrance side.
B. Slide
the Rear Sheet Metal Cabinet/Cover off of the StreamPunch.
NOTE: You do not need to lift upward and you do not need to remove the Top
Cover.
B
Step 6: To remove the J2 Flipper (C), Door Latch.
A. Remove only one (the one closest to the frame) of the “E” Rings of the J2 Flipper
on the right end (front Door side).
B. Push the J2 Flipper in toward the front Door until it clears the rear frame.
C. Pull the entire J2 Flipper, Door Latch out and set it aside.
Step 7: Unhook spring from the Docking Plate (D) and Door. Remove the “4” screws that
secure the Docking Bracket. Remove, and set aside.
To Next Page
Loading...
