SIDE
FRONT DOOR
D
SIDE
SIDE
PAPER ENTERANCE
Step 8: To remove the Rear Aligner, Idler Paper Guide Assembly
A. Remove “2” E-Rings from the Pivot Shaft.
B. Slide the Shaft all the way out through the front of the StreamPunch.
C. Remove the “2” Nylon Bearings.
D. Remove and set aside the Rear Aligner, Idler Paper Guide Assembly.
Step 9: To remove the curved sheet metal Exit Paper Guide Assembly
A. Remove the “4” Screws (2 rear and 2 front) of the curved sheet metal Exit Paper
Guide Assembly
B. Unplug the Sensor
C. Pull the entire sheet metal Exit Paper Guide Assembly out, set aside.
To Next Page
Loading...
