34
Step 12: Remove the Green Belt Aligner Roller Assembly by removing the “4” screws.
Important: Leave the Coupler attached.
Assembly Process
Step 13: Stretch the new green belt onto the Aligner Roller Assembly, green side out.
• Take care when handling the Aligner Roller Assembly so as not to damage the Flex
Coupling.
• Rotate the shaft to confirm that the belt tracks properly.
Step 14: Slide the Aligner into place, loosely
attach the “4” Pan Head Screws with the “4” Lock
Washers.
BELT
STRETCH
ROTATE
Check that the metal surface of the Aligner Roller Assembly is flush with the Sheet Metal surface of
the Paper Guide. A 12” metal ruler works well to check this adjustment. Slip the ruler under the green
belt and press it flat against the two surfaces. Adjust the Aligner and snug
the screws when perfectly
flush.
NOTE: The green belt should look like the drawing shown after step 11.
As a double check, hold the entire Paper Guide assembly up so that you can visually inspect the
alignment between the sheet metal surface and
the metal surface of the Aligner. The Green Belt should
appear to be even and just floating above the surface of the sheet metal.
To Next Page
Loading...
