AFTER ASSEMBLY
4.7 BACK GAGE AND CHAD CONTROL MECHANISM -
ADJUSTMENT, ASSEMBLY / DISASSEMBLY PROCEDURE
General Description:
The StreamPunch Chad Control Mechanism directs Paper Chad into the Chad Disposal Container,
significantly reducing the amount of Chad that could flow through the paper path. There will be some
Chad that falls outside the Chad Container. In one circumstance, when the customer changes their
Die Set, some Chad always comes with the Die and falls to the bottom of the machine or to the floor.
As a general practice, it is a good Preventative Maintenance practice to vacuum the inside of the
StreamPunch periodically.
4.8 INSTALLATION STEPS
Step 1: Disconnect power and communication cable.
Step 2: Open door and remove Die Set, chad bin, and rear cover (opposite the door).
NOTE: Once you remove the screws that secure the rear cover, it will slide out from under
the top cover. You do not need to remove the top cover.
To Next Page
Loading...
