Punch UNIT PU5000 (B831)
SM 1-107 B234/B235/B236/D101/D102/D103
Installation
11. Position the 2 mm spacer [A] and attach the punch unit [B] ( x 2, M3 x 10).
12. Use one of the screws removed from the motor protector plate to fasten the
remaining two spacers to the frame as shown.
NOTE: These extra spacers can be used to adjust the position of the punch
holes (front to rear, across the page).
13. At the front, fasten the punch unit knob [C] ( x 1).
B831I105.WMF
B831I108.WMF
[A]
[B]
[C]
To Next Page
Loading...
