Installation of MFP controller Options
SM 1-127 B234/B235/B236/D101/D102/D103
Installation
1.15.2 MERGING APPLICATIONS ON ONE SD CARD
Overview
The machine has three SD card slots:
• Slot 1 (C1) is used for the system card (never remove the system SD card from
Slot 1.
• Slot 2 (C2) is used for application programs
• Slot 3 (C3) is used for servicing (firmware updates)
Only one SD card slot (C2) is available for SD card applications. If the customer
wants to use more than one application, the applications must be copied onto the
same SD card.
Important
• The data necessary for authentication is transferred with the application program
to the target SD card.
• Do not use an SD card if it was used with a computer before this time. Correct
operation is not guaranteed if this type of SD card is used.
• The SD card is the only evidence that the customer is licensed to use the
application program. Also, the service technician may occasionally need to check
the SD card and its data to solve problems. For these reasons SD cards must be
stored behind the copier emblem cover. (Pg. 1-130)
• A licensing agreement prohibits copying of the PostScript SD card. However, you
can copy any application from another SD card to the PS3 SD card.
• Once an SD card has been used to combine applications on that card, that SD
card cannot be used for a different function.
• Never remove the System SD Card from Slot C1.
• Before uploading to an SD card, always make sure that the write-protect switch
is OFF. (It is very easy to accidentally turn on the write-protect switch when
inserting or removing an SD card.)
To Next Page
Loading...
