COMMON PROCEDURES
3-6
3.3 COMMON PROCEDURES
3.3.1 PULLING THE DEVELOPMENT UNIT DRAWER OUT
NOTE: These illustrations show removal with the hex driver provided to the
customer, but the screws can be removed with any Phillips head (+) screwdriver.
11. Open the right front door.
12. Remove the black screws at n.
13. Take off the inner cover o.
Important! This cover functions as a duct in
the ventilation path of the machine. It must
always be reinstalled.
14. Remove the ground plate ( x1).
1
1
1
2
B234R903.WMF
B234I110E.WMF
To Next Page
Loading...
