DEVELOPMENT AND TONER SUPPLY
SM 3-73 B234/B235/B236/D101/D102/D103
Replacement
Adjustment
9. When you are ready to remove the dust cleaner [A]:
• Push in the dust cleaner slightly about 10 mm (1/2") . This releases the flap
from the back of the blade and allows it to lie flat.
• Tilt the dust cleaner up to about a 45-degree angle , then slowly pull it out of
the slit .
• Turn the dust cleaner slightly to the left or right if you feel any resistance.
10. After removing the dust cleaner, rotate the development roller toward you about
10 mm (1/2").
11. Use a vacuum cleaner to remove toner dust or developer.
Important:
• Collect all of the paper dust and developer.
• Never touch the front surface of the development roller.
12. Repeat the cleaning steps 5 or 6 times.
13. Hold the development unit upside down, and shake it gently to remove any
remaining paper dust or developer.
14. Clean the work area thoroughly with the vacuum cleaner.
15. To complete the procedure, return to Step 8 in Section 3.8.3.
1
45
3
2
B234R519.WMF
[A]
To Next Page
Loading...
