Ricoh B234 - Page 61

COPIER (B234/B235/B236/D101/D102/D103)
SM 1-23 B234/B235/B236/D101/D102/D103
Installation
4. Remove the bracket [A] ( x1).
5. Disconnect the toner hopper [B]
( x1,  x2)
6. Tilt the hopper slightly when you
remove it.
7. Pour the developer into the
development unit.
• Move the toner packet [C] from side
to side while you pour a small
amount of toner across the length of
the gap.
• Stop pouring and turn the knob [D] so
the toner settles into the
development unit.
• Repeat this sequence until the
packet is empty.
8. Reattach the hopper to the development unit. ( x1,  x2)
Important:
• Confirm that the TD harness is connected properly.
• Confirm that the harness is not pinched.
9. Set the connected harnesses between the toner hopper and the metal plate.
10. Re-attach the bracket (see the previous page) ( x1).
B234I902.WMFF
B234I903.WMFF
[B]
[D]
[C]
[A]