ADJUSTMENT
SM 39 B546
Booklet
Finisher
B546
3.2 ADJUSTMENT
3.2.1 SHIFT TRAY HEIGHT
After replacing the finisher board or shift tray height sensor, always do this
adjustment.
1. Remove the upper rear cover.
2. Turn on dip switches 3 -1 and -4 on the finisher board.
3. Put blank paper (A4/8
1/2" x 11") on the shift tray.
4. Press switch 1 (SW1) on the finisher board.
The finisher automatically adjusts the shift tray height when switch 1 is pressed.
• After performing the adjustment, the shift tray will return to home position.
• During the adjustment, LED 1 flashes. After performing the adjustment, LED
1 turns on and remains on.
• If the automatic adjustment fails, the finisher stops and LED 1 turns off.
5. Turn off dip switches 3 -1 and -4, then turn off the copier main switch.
SW1
SW2
Dip Switch 3
LED 2
LED 1
B546R550.WMF
1
Dip Switch 3
23 56784
ON
B546R551.WMF
To Next Page
Loading...
