4. Attach tray strut [1] to base strut Á ( x2, Nuts x2, Spacers x4)
5. Attach tray strut [2] to base strut ® ( x2, Nuts x2, Spacers x4).
6. Attach the small tray [1] to the tray struts [2] ( x6).
7. Hang the guides [3] on top of the tray (¬ long, Á short).
8. Hang the stoppers [4] on the tray. (These stoppers can be moved to a higher or lower position to
accommodate the length of the copy.)
2. Installation
100
To Next Page
Loading...
