2. Push the fan fold unit [1] against the back of the machine [2].
3. Make sure that the fan fold unit is aligned properly with the back of the main machine.
• At the top and on both sides, make sure that upper positioning bracket À of the fan fold unit is
touching the back of the main machine Á. There must be no gap here.
• At the right bottom side, make sure that the lower positioning bracket  of the fan fold unit is
touching the outer arm of the joint bracket à of the main machine.
Bridge Unit BU6500 (D407) Folder FD6500A (B889)
135
To Next Page
Loading...
