[E] File format converter board ( x2)
3. Remove the controller box faceplate [A] ( x6).
4. Remove the controller box cover [A] ( x18).
5. Insert the edge connector of the gigabit Ethernet PCB [B] into the controller board.
• If the scanner unit will be installed, you must also install Memory Unit Type 7140 1GB (D444)
[C]. Do this now while the controller box cover is off.
6. Reattach the controller box cover and faceplate.
7. Reattach all slot covers (or reinstall any boards, including the file format converter board).
2. Installation
212
To Next Page
Loading...
