3. Fasten the scanner unit at the right corner [1] ( x2) and left corner [2] ( x2).
Scanner Relay Board, Cable Connection
1. At the rear of the main machine, insert the scanner relay board [1] into the side of the SIB [2].
2. Fasten the relay board bracket [3] to the main machine (x1 M3).
3. At the left rear corner of the table [1], route the large cable harness [2] from below through the hole.
4. Set the bracket [3] at the left top corner of the table and fasten it (x1).
2. Installation
240
To Next Page
Loading...
